TAP-28 - A “throw away” PIC board - TAP-28 ICSP Connection

TAP-28 ICSP Connection

By far, the easiest way to load program code into the TAP-28 board is via ICSP programming. There is no need to remove the microcontroller for programming or to install a bootloader.

The PICkit 2 from Microchip offers exceptional value for its price. A six-conductor jumper cable is the best way to connect the PICkit to the TAP-28, although it may be directly connected if a simple 6 pin header is installed instead of the suggested keyed connector. The PICkit can also power the board during development so that a power supply need not be connected.